Electronic Braking System and Electronic Leveling Control


Two day course
On-site or classroom based
IMI approved course

The new Enviro range of buses incorporate EBS & ELC as standard, further enhancing the safety and operation of your buses. Both systems are made by Knorr Bremse and use the same diagnostic equipment and share information on the CAN network. It makes sense to combine the two systems into one training course. Delegates will learn efficient and safe diagnostic techniques for fast & reliable fault finding, including function, location, testing and repair of components & use of diagnostic equipment.

This two day course can be attended by Technicians involved in the maintenance and repair of EBS & ELC systems. Delegates will be encouraged to develop their understanding by participating in practical exercises & discussion throughout the course.

Delegates will learn to carry out all maintenance and repair procedures to the EBS & ELC systems using laptop based diagnostics and will be able to clear faults and confirm correct operation following installation of new components.

Course content

  • Classroom presentation using components for demonstration, identification and testing.
  • Digital multimeter skills to improve fault finding.
  • EBS & ELC troubleshooting and diagnostics on training chassis.
  • Practical assessment including pre-set faults on training chassis.
  • Written assessment.
  • All Students will receive full course material on CD.

Additional Information

  • Students must provide their own clean safety shoes for workshop areas.
  • Joining instructions and site information will be sent to you.
  • Results of individual assessments are available for employers on request.
  • Certificates issued to successful delegates. Valid for three years unless stated otherwise
  • IMI certificate awarded to successful delegates. 80% pass rate required on assessment

Right Course. Right Time. For you.

Talk to us about training